#Flux power not working Pc#

Multi meter i could just unplug everything and worry about it plugged it you method would need me to have it power on while in side it I cant do that, the wires are way to short for that I barely have enough wire to connect sub to board and coil to the board and even if the wires where long enough I would not. I do have multi meter I will try that next time i go in it.

#Flux power not working Pc#

been playing the set threw my iphone 3.5m jack and they still sound amazing all the input work the sub volume and satatlies power on volume up and down work great, but on dead silence the buzz is highly annoying, it using 10a 250v fuse atm cause that all that i had that came with fuse holders which just means it gona have higher tolerance before it blows, I gona see if I can find 2a 250v but i dont think I have ( also dont think fuse could be cause of buzz?), I dont trust my work here and i could careless about the iphone so i not ready to hook up to my pc for these reason, when I get T2A 250v amp and dont blow i will attempt that. Ok well cause I had it apparnt I also re flow all the wires in the satellites, made no difference. Worse case scenary both remain dead, at point i just pratice soldering for next time i need to do so and will have stuff i need. Solder kit has every thing i should need including tester to see joint and cables are workingĤ700 uf 35v same UF and volt and temps rangeįuse holder come with 5x20 5a and 10a fuse but I have that still good 5x20 2a 240v fuse well i assume it 5x20 fuse cause it s. and like said I have Remote commander for DA555ES AVR that dont turn on that need to work or i lose 99% function from my avr, before it just stop working permanently it worked at random I go to use it would be working complete with lcd screen, I would come back to week later and it not work and come back few day later it would be work complete with lcd screen, so it was like battery power was not getting to board and i know one solder joints to one battery spring that goes to board are lose and had hole pin side where connector went into solder. I really want these ACS 48 working properly again. I watch few the other day, if understanding you correct to get leak caps out use flux paste to clean joint on bad caps that leaked then apply some soilder to tip and then pull them out? I first need to clean the leaked brown fluid on board from caps i assume not gona be able to pull them out with out doing soo. Oh i watched videos, last time i tried soldering things which was mouse where i tried to switch out the switches, that failed cause i had solder but it was not fine tip so thing got burnt.